Where to set #Version ?

[ArthrexGmbH]

Dear ir Prognosis Community.

I am working on my Wallboard (displays for Trunk, Route Pattern, Phones...) for my Cisco UC environment. All seem to be fine but if I start my "Wallboard" in Prognosis Desktop Client I got the "Execute Prompt" (please take a look to picture) where I am asked for the "#Version" Parameter.

Is there a possibility to set this parameter by default ? 

Christian

[SCOTT_BALDWIN · Accepted solution]

Hi @ArthrexGmbH,

The screen capture shows the value for the #Version variable is set to 12 as a default.

The challenge here is the Display is expecting a variable to be passed to the Display from a drilldown in an originating Display. As long as the #Version variable is expected to be passed from another Display, the pop-up will always be shown, even though the #Version variable already has a default value of 12.

2 potential solutions:

1. Change the Display with the #Version variable pop-up to be hard coded to use 12 for the version instead of using a variable.
2. Create or use a Display with a drilldown and configured to pass the information into the #Version variable.

Both of these options will require more than basic user knowledge of Prognosis. The following links are to Prognosis Online Help pages specific to Displays:

• Displays: Shows the entire Displays section with sub-links.
• Creating a Display: Basics of Display creation.
• Creating a Drill-down: How to create a drilldown in a Display.

If additional help is needed, please contact the Account Manager for additional Prognosis training or to have Professional Services create any Displays needed.

Thank you,
Scott Baldwin

[ArthrexGmbH]

Thanks for informations an Link's :-)