cancel
Showing results for 
Search instead for 
Did you mean: 

Where to set #Version ?

ArthrexGmbH
05 Base Camper

Where to set #Version ?

Dear ir Prognosis Community.

I am working on my Wallboard (displays for Trunk, Route Pattern, Phones...) for my Cisco UC environment. All seem to be fine but if I start my "Wallboard" in Prognosis Desktop Client I got the "Execute Prompt" (please take a look to picture) where I am asked for the "#Version" Parameter.

 

Is there a possibility to set this parameter by default ? 

Christian

1 ACCEPTED SOLUTION

Accepted Solutions
SCOTT_BALDWIN
Expert

Re: Where to set #Version ?

Hi @ArthrexGmbH,

 

The screen capture shows the value for the #Version variable is set to 12 as a default.

 

The challenge here is the Display is expecting a variable to be passed to the Display from a drilldown in an originating Display. As long as the #Version variable is expected to be passed from another Display, the pop-up will always be shown, even though the #Version variable already has a default value of 12.

 

2 potential solutions:

  1. Change the Display with the #Version variable pop-up to be hard coded to use 12 for the version instead of using a variable.
  2. Create or use a Display with a drilldown and configured to pass the information into the #Version variable.

Both of these options will require more than basic user knowledge of Prognosis. The following links are to Prognosis Online Help pages specific to Displays:

If additional help is needed, please contact the Account Manager for additional Prognosis training or to have Professional Services create any Displays needed.

 

Thank you,
Scott Baldwin

 

View solution in original post

2 REPLIES 2
SCOTT_BALDWIN
Expert

Re: Where to set #Version ?

Hi @ArthrexGmbH,

 

The screen capture shows the value for the #Version variable is set to 12 as a default.

 

The challenge here is the Display is expecting a variable to be passed to the Display from a drilldown in an originating Display. As long as the #Version variable is expected to be passed from another Display, the pop-up will always be shown, even though the #Version variable already has a default value of 12.

 

2 potential solutions:

  1. Change the Display with the #Version variable pop-up to be hard coded to use 12 for the version instead of using a variable.
  2. Create or use a Display with a drilldown and configured to pass the information into the #Version variable.

Both of these options will require more than basic user knowledge of Prognosis. The following links are to Prognosis Online Help pages specific to Displays:

If additional help is needed, please contact the Account Manager for additional Prognosis training or to have Professional Services create any Displays needed.

 

Thank you,
Scott Baldwin

 

ArthrexGmbH
05 Base Camper

Re: Where to set #Version ?

Thanks for informations an Link's :-)